Enterasys SecureStack A2 A2H123-24 Przewodnik Instalacji Pobierz pdf (Strona 38)

Connecting AC and RPS-SYS Power

3-12 Hardware Installation

Connecting AC and RPS-SYS Power

AC Power

ToconnectaswitchtotheACpowersource,refertoFigure 3‐6andproceedasfollows:

1. Plugthepowercord

intotheswitchACpowerconnector.

2. Plugtheotherendofthepowercordintoaded icatedgroundedACoutlet(not

shown).Thetypeofpoweroutletandpowercordarecountry‐dependent.

Note: The power supply in the switch has automatic voltage sensing that allows

connection to power sources ranging from 100 to 240 VAC.

Note: If you plan to connect all the switches quickly to allow automatic Manager selection,

wait until all switches are fully operational before proceeding to the next step.

If you plan to power up each switch and allow it to become fully operational before

applying power to the next switch, proceed to the next step.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 63 64

Brak uwag

Enterasys SecureStack A2 A2H123-24 Przewodnik Instalacji Strona 38