Enterasys VHSIM2-A6DP Podręcznik Użytkownika Pobierz pdf (Strona 261)

VLAN Classification Configuration Screen

802.1Q VLAN Configuration Menu Screens 8-33

8.8.3 Assigning a Classification to a VID

To assign a Classification to a VID, proceed as follows:

1. Use the arrow keys to highlight the VID (VLAN identification) field.

2. Type in the appropriate VID. Press ENTER.

3. Use the arrow keys to highlight the Classification field.

4. Press the SPACE bar to step to the appropriate Classification. Table 8-8 lists the

subclassification associated with each Classification (examples of classifications:

Ethernet II Type, 802.3 SAP, IP TOS, IP Protocol Type, etc.).

5. Use the arrow keys to highlight the subclassification field to the immediate right of the

Classification field. The name of the field changes depending on the selected Classification, as

shown in Table 8-8 (examples of subclassification: Ethernet II Type, SSAP/DSAP (803.2), Type

of Service, IP Protocol Type, etc.).

6. Press the SPACE bar to step to the appropriate protocol. In some cases, there is only one

selection and a value needs to be entered. This is indicated by bold zeros. Table 8-8 lists the

possible selections associated with each subclassification (examples: IPX, AppleTalk,

NetBIOS, Banyan Vines, 000.000.000.000, 0x00000000, etc.).

7. In some cases, a selection in the subclassification field requires a value to be entered in a third

field to the right of the subclassification field. If so, use the arrow keys to highlight that third

field and type in the appropriate value. Otherwise, go to step 8.

8. Use the arrow keys to highlight the ADD command field.

9. Press ENTER to save the VID and Classification settings. After a brief delay, the Classification

Rule will display in the top half of the screen.

NOTE: It is strongly recommended that you read Section 8.8.1 for more information

concerning classification before configuring the switch module. Incorrect configuration

will affect network operation.

NOTE: After creating a classification rule you must assign it to the appropriate ports

using the Protocol Port Configuration screen described in Section 8.9.

1 2 ... 256 257 258 259 260 261 262 263 264 265 266 ... 435 436

Brak uwag

Enterasys VHSIM2-A6DP Podręcznik Użytkownika Strona 261