ISSUES RESOLVED IN E8.2.1.1
10/24/01 P/N: 9038090-17 CUSTOMER RELEASE NOTES Page: 10 of 34
F0615-F Subject to Change Without Notice
ISSUES RESOLVED IN E8.2.1.1
• Because all of the issues in the following tables have been resolved, a statement with each issue
declaring its resolution has not been included.
• Resolved Issues are sorted alphabetically by topic heading.
Access Control List (ACL) I.D.
Commented-out ACL commands will be negated after an “acl-edit” mode command is performed
and the change is saved. This issue occurs only if no other commented out lines exist in the
configuration.
F1649
Attempting to delete a line using acl-edit will lock ACL commands into the configuration database. F1675
In order to delete all ACLs, a reboot must be performed after a hot-swap. F1692
Address Resolution Protocol (ARP) I.D.
If the link to an end-station from an STP-enabled port is disconnected, the ARP table will clear. If the
X-Pedition has attained a considerable amount of ARP entries, disconnecting this link could,
therefore, introduce an ARP broadcast storm to the network.
This issue originally appeared in E8.1.0.3, and was resolved in E8.1.0.7.
F1451
The arp add command now includes an additional vlan parameter. This parameter enables the
specification of a VLAN for the static ARP entry, allowing packets destined for a specified IP
address to be forwarded through all ports in the VLAN associated with that IP interface.
NOTE: The vlan and exit-port parameters cannot be used simultaneously.
This issue was added in E8.1.0.9.
F1474
When the CLI is used to add an ARP entry, the system incorrectly allows the inclusion of both the
exit-port and vlan parameters in a single command. This issue was resolved in E8.2.0.2.
F1559
Static ARP entries configured on a VLAN rather than an exit port will be modified when new ARP
traffic is seen. This issue originally appeared in E8.1.0.9, and was resolved in E8.1.0.12.
F1747
AppleTalk / Advanced Routing Engine (ARE) I.D.
AppleTalk nodes (iMacs, for example) are able to communicate only in the default zone. When an
AppleTalk node's zone membership is changed via the chooser, those nodes are unable to browse
or communicate with any other nodes in the new zone. If the AppleTalk node's membership is
changed back to the default zone, communication between nodes will resume. This issue was
resolved in E8.1.0.9.
F1514
If a partial command for either save active (i.e. “save ac”) or save startup (i.e. “save star”) is
entered while in ‘are-config’ mode, the command line will not complete itself, and will not be
recognized. Hitting the space-bar will cause the commands to complete as they should.
NOTE: This issue occurs ONLY when the user Telnets into the router over the network.
This issue was resolved in E8.1.0.9.
F1521
AppleTalk ping results will not display during a Telnet management session. A serial console
management session works correctly.
F1583
Asynchronous Transfer Mode (ATM) I.D.
The second port of an ATM card will not pass multicast/broadcast traffic when the interface type is
set to "point-to-point".
NOTE: The default ATM interface type is "broadcast"; when in this mode, the ATM card passes
multicast/broadcast traffic on both ports.
F1456
(83 strony)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji