ISSUES RESOLVED IN E8.2.1.1
10/24/01 P/N: 9038090-17 CUSTOMER RELEASE NOTES Page: 18 of 34
F0615-F Subject to Change Without Notice
Switch Fabric Card I.D.
When a switch fabric card is hot-swapped into an X-Pedition 8600, it is not fully ready to take over
when the other switch fabric either fails or is hot-swapped out. This results in a fail-over time, which
is slightly longer than it should be. This issue was resolved in E8.1.0.9.
F1531
System I.D.
With this release, the System Firmware has been enhanced to prevent the use of unsupported
hardware configurations. The following error messages will appear when an unsupported
configuration is attempted:
%SYS-E-CPU_CHASSIS_PROBLEM_1
%SYS-F-CPU_CHASSIS_PROBLEM_2
%SYS-F-CPU_CHASSIS_PROBLEM_3
%SYS-E-CM_TYPE_MISMATCH
F0899
With this release, the system names for the X-Pedition E5, E6, and E7 modules have been
changed. Previously, they were referred to as "SSR 2000/6600", regardless of the system type. The
System Firmware now detects the individual system type and alters the name accordingly. The
individual system names are as follows:
• E5 = "5SSRM/5C105"
• E6 = "6SSRM/6C105"
• E7 = "6SSRM/6C107"
This issue was resolved in E8.2.0.2.
F1233
When the system set idle-time command is configured, timeouts will not occur if the console or a
Telnet session is left paginated. This presents a security risk. This issue was resolved in E8.1.0.9.
F1507
The X-Pedition may freeze after extended periods of use. While in this condition, no console or
Telnet access is possible, and the system will not pass traffic. This issue was resolved in E8.1.0.10.
F1622
Terminal Access Controller Access Control System+ (TACACS+/RADIUS) I.D.
When responding to the tacacs-plus set source x.x.x.x command, the X-Pedition incorrectly
allows any IP address as the source. The source IP address should already be associated to an
interface on the router.
Example: If tacacs-plus set source 2.2.2.2 is entered, the X-Pedition should first verify that an
interface exists with an IP address of “2.2.2.2”. If not, an error should display upon save active, and
the command should be errored-out in the active configuration. This issue was resolved in E8.1.0.8.
F1197
TACACS +/RADIUS accounting functions may produce memory leaks. This issue was resolved in
E8.1.0.12.
01760
Telnet I.D.
When using Telnet to connect to an X-Pedition, utilizing certain UNIX clients as intermediate hops,
the session may not connect.
In this case, the client will display the following:
Trying 10.136.64.77...
Connected to 10.136.64.77.
Escape character is '^]'.
Connection closed by foreign host.
In addition, Telnet connection to the X-Pedition may occasionally fail when the router is busy. This
issue was resolved in E8.1.0.7.
F1082
(83 strony)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji